Keysight Technologies InfiniiVision 3000T X Series, Programmer'S Manual

Page: 1084 / 1420

1084 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
33
:TRIGger Commands
:TRIGger:ZONE:STATe
(see page 1276 )
Command Syntax
:TRIGger:ZONE:STATe <on_off>
<on_off> ::= {{0 | OFF} | {1 | ON}}
The :TRIGger:ZONE:STATe command enables or disables the zone qualified trigger
feature.
When the zone qualified trigger is on, the zone(s) are actively being used to qualify
the trigger.
Note that the :TRIGger:ZONE<n>:STATe setting must also be ON for a zone to be
active.
Note that :TRIGger:ZONE:STATe mimics the behavior of the [Zone] key on the front
panel, and :TRIGger:ZONE<n>:STATe mimics the behavior of the Zone 1 On and
Zone 2 On softkeys. At least one zone's state must be on for the Zone Trigger
feature (:TRIGger:ZONE:STATe) to be on. When the states of both individual zones
are turned off, Zone Trigger is automatically turned off. In this case, when Zone
Trigger is turned back on Zone 1 is forced to on. Otherwise, if at least one zone
was on when Zone Trigger was turned off, the same configuration of individual
zone on/off states will be restored when Zone Trigger is turned back on.
Query Syntax
:TRIGger:ZONE:STATe?
The :TRIGger:ZONE:STATe? query returns whether the zone qualified trigger
feature is enabled or disabled.
Return Format
<on_off><NL>
<on_off> ::= {0 | 1}
See Also • ":TRIGger:ZONE<n>:STATe" on page 1088
• ":TRIGger:ZONE:SOURce" on page 1083