Getting Started
2
Keysight Infiniium MXR-Series Real-Time Oscilloscopes User's Guide
31
Verifying Basic Oscilloscope Operation
1
Connect one end of the passive probe cable to oscilloscope input channel 1.
2
Connect the other end of the passive probe cable to the front panel Probe
Comp terminal with the square wave label.
3
Press
[Default Setup]
on the front panel.
The display will pause momentarily while the oscilloscope is configured to its
default settings. The oscilloscope is now in a known operating condition.
4
Press
[Auto Scale]
on the front panel.
The display will pause momentarily while the oscilloscope adjusts the time/div
setting and vertical scale so the oscilloscope can best display the input signals.
You should then see a square wave with about four cycles on screen and a
peak-to-peak amplitude of approximately five divisions.
If you do not see the waveform, make sure your power source is adequate, the
oscilloscope is properly powered on, and the cable is connected securely to the
front panel connector output.
5
Move the mouse around the mouse surface and verify that the on-screen
pointer follows the mouse movement.
6
Press the
[Touch]
key on the front panel to turn on the touch screen. Press and
hold your finger to the screen. A right-click menu appears, which verifies that
the touch screen is working properly.
Figure 10
Verifying basic oscilloscope operation
~
~
+
+
Front panel connector
with square wave label
Channel 1 input
Summary of Contents for Infiniium MXR Series
Page 1: ...Keysight Infiniium MXR Series Real Time Oscilloscopes User s Guide...
Page 10: ...10 Keysight Infiniium MXR Series Real Time Oscilloscopes User s Guide Index...
Page 20: ...20 Keysight Infiniium MXR Series Real Time Oscilloscopes User s Guide 1 Setting Up...
Page 106: ...106 Keysight Infiniium MXR Series Real Time Oscilloscopes User s Guide 6 Testing Performance...
