Keysight Technologies Infiniium MSOV 084A, Service Manual

Page: 129 / 164

Replacing Assemblies
5
Infiniium V-Series Oscilloscopes Service Guide 129
Removing and replacing fans
1
Remove the top panel, bottom panel, and front panel as described earlier.
2
Remove the four M3 screws (2 from each side) connected to the fan bracket.
3
Disconnect the fan harness cables from the fans you want to replace.
)
4
Clip off the end of the top two fan mounts from the fan as shown, leaving the
bottom mounts attached, and slide the fan out. Repeat for each fan that needs
to be replaced.
)
WARNING
AVOID INJURY! The fan blades are exposed both inside and outside the chassis.
Disconnect the power cable before working around the fan.
Figure 76
Figure 77