Keysight Technologies FieldFox A Series, User Manual

Page: 661 / 756

Keysight N9927-90001 User’s Guide 661
System Settings
System Configuration
— Static DNS - Enter the Static DNS – including periods - in the format
nnn.nnn.nnn.nnn
— Apply Settings Choose from:
— Power Up The above settings take effect when the FieldFox is
started.
— Now The above settings take effect immediately.
— Press Done Edit when finished.
Power ON
When the FieldFox is without a power source, this setting allows the FieldFox
to power ON as soon as a charged battery or the DC Adapter is inserted
without pressing the power button.
How to set Power ON
— Press System 7
— Then System Configuration
— Then More
— Then Power ON
— Then choose from the following:
— Auto The FieldFox will power ON when a charged battery or the DC
Adapter is inserted.
— Manual The FieldFox will power ON only when the power button is
pressed.
FieldFox Package Installer (N995xA, N996xA, and applies to:
N991xA/2xA/3xA units with serial number prefixes ≥ 5607)
The FieldFox Package Installer enables you to download new versions of
firmware from either a USB memory or SD Card. Additionally, the Utility softkey
enables you to backup user files or restore user files.
How to run the Installer
To make the LAN settings persist after power up, toggle Apply Settings to
Now then back to Power Up. You should see a message indicating that the
LAN config file was saved.
Before running the Installer to update your firmware, you might want to
back up your user data. Refer to “How to restore files” on page 662 .