Keysight Technologies FieldFox A Series, User Manual

Page: 345 / 756

Keysight N9927-90001 User’s Guide 345
5G Rapid Prototype Phased Array Antenna – Option 360
How to Set Up Phased Array Antenna Settings
5. Entering the phased array antenna measurement type:
Refer to
“Data Formats:” on page 332 .
Select Measure :
— Measure —choose:
— Bore-Sight or
— Heat Map or
— Polar ANT or
— Park ANT
6. Using the table to enter phased array antenna settings, presetting the
antenna, setting the antenna LAN IP, and clearing the graphics:
Refer to
Figure 15 on page 351 .
Select Meas Setup :
— Antenna Settings —choose:
— Ball Antenna > LAN Address
— Settings –choose:
—— Res BW or
—— Video BW
—— Beam Width
— Array Antenna –choose:
—— Center
—— Azimuth Ref
—— Elevation Ref
— Polar Display > Ref
— Sweep > Dwell Time (Optional. For pulsed RF
measurements it is recommended that the Dwell Time is
increased.)
— Sweep > Max Hold (Optional. For pulsed RF
measurements it is recommended that Max Hold is set to
OFF when using the Heat Map display. (Default = OFF).)
— Preset Antenna presets the antenna settings factory defaults.
— Ant LAN IP enter the Ball antenna’s LAN IP. First three fields must
match the FieldFox’s static IP address (default: 192.168.1.10). Refer
to Figure 14 on page 350 .