Keysight Technologies E5260 Series, Programming Manual

Page: 60 / 350

1- 48 Keysight E5260/E5270 Programming Guide, Edition 4
Programming Basics
Programming Tips
To Use Programs for Keysight 4155/4156
Keysight E5260/E5270 supports commands similar to the FLEX command of the
Keysight 4155B/4156B/4155C/4156C Parameter Analyzer. However, not all
command sets are fully compatible. To reuse the programs created for the Keysight
4155/4156, the following modifications are required.
• To remove all unsupported commands
Table 1-7 shows the commands not supported by the E5260/E5270. You cannot
use these commands. The SCPI commands and 4145 syntax commands are not
supported either.
The E5260/E5270 does not need the US and :PAGE commands that are
necessary to change the control mode of the Keysight 4155/4156.
• To check and correct the command syntax
Even if the command name is the same, the available parameters and values may
be different. Check and correct the command parameters.
• To change the FMT command parameter
Use the FMT 21, FMT 22, or FMT 25 command that sets the data output format
compatible with the 4155/4156 ASCII format.
• To delete RMD?
The E5260/E5270 does not need the RMD? command that is necessary to put
the measurement data into the output data buffer of the Keysight 4155/4156.
• FL command
The initial setting of the FL command is different. It is ON for the Keysight
4155/4156, and OFF for the E5260/E5270.
Add the FL1 command to use the filter.
• AV command
This command is used to set the A/D converter of the E5260/E5270.
To set the high resolution ADC installed in the E5270B, use the AAD and AIT
commands.
• To replace TI?/TV?/TTI?/TTV? with TI/TV/TTI/TTV respectively
• To replace WM with LSM for the linear search measurement
• To replace TSQ? with TSQ