34
DP0010A/11A/12A/13A Differential Active Probes User’s Guide
4
Safety and Regulatory Information
Safety Checks and Warnings
These products have been designed and tested in accordance with accepted
industry standards, and have been supplied in a safe condition. The
documentation contains information and warnings that must be followed by the
user to ensure safe operation and to maintain these products in a safe condition.
WARNING
If the probe assembly is used in a manner not specified by the
manufacturer, the protection provided by it may be impaired.
WARNING
Observe Probe Voltage Ratings.
Do not apply any electrical potential to the probe input that
exceeds the maximum rating of the probe. See
maximum input voltage ratings.
These probe assemblies are NOT intended for measurements on
mains circuits (CAT II, CAT III, and CAT IV).
WARNING
Periodically inspect the probe wires and cables. Do not operate
with visible/suspected damage. If you suspect a damage, have
it inspected by a Keysight authorized service personnel.
WARNING
Do not install substitute parts or perform any unauthorized
modification to the probe / accessory.
Do not attempt internal service or adjustment. Service should
be carried out by a Keysight Technologies authorized service
personnel. For any service needs, contact Keysight
WARNING
Must be Grounded
Probe must be fully connected to the oscilloscope prior to
connection to the device under test. The oscilloscope must be
properly grounded.
Probe must be disconnected from the device under test prior to
disconnecting from the oscilloscope.
WARNING
Indoor Use Only.
Do not operate in wet/damp environments. Keep product
surfaces dry and clean.
