Keysight Technologies B2900 Series, User Manual

Page: 168 / 234

5-14 Keysight B2900 User’s Guide, Edition 5
Front Panel Operations
To Set Source Output
NOTE The Limit (Compliance) value can be set to both positive and negative directions
individually by setting ON to the V/I Limit for Each Polarity field on the Display
Preference dialog box. See
“Display Preference dialog box” on page 4-51 .
To Set Output Range
For details on this function, see “Ranging Mode” on page 6-4 and “Range
parameters” on page 4-12 .
1. Press the View key to display the Single view. If the Range parameters are not
displayed, press the Hide XXXX assist key.
2. Move the field pointer to the Source Volts: Spot (voltage source range) or
Source Amps: Spot (current source range) field.
3. Press the rotary knob to change the pointer status to EDIT.
4. Press AUTO to set the auto range operation or FIXED to set the fixed range
operation. The pointer status is changed to MOVE.
5. Move the field pointer to the range value setup field (on the right side of the
Source Volts: Spot or Source Amps: Spot field).
6. Press the rotary knob to change the pointer status to EDIT.
7. Press an assist key to set the following value.
For the auto range operation: Minimum range of the range operation
For the fixed range operation: Range used for source output
To Set Pulse Output
For details on this function, see “Pulse Output” on page 6-7 .
1. Press the View key to display the Single view.
2. Press the Show Pulse assist key to display the Pulse parameters. For details on
the parameters, see “Pulse parameters” on page 4-16 .
3. Move the field pointer to the Pulse field.
4. Press the rotary knob to change the pointer status to EDIT.
5. Press the ON assist key. The pointer status is changed to MOVE.
6. Move the field pointer to the pulse parameter setup field (Peak, Delay, or
Width).