Keysight Technologies B1542A Pulsed IV Package, User Manual

Page: 100 / 160

5-32 Keysight B1542A User’s Guide, Edition 10
PLSDIV Test Definitions
PLSDIV Setup
PLSDIV Setup
This test definition is used to perform the system setup and the compensation of the
pulsed IV test system. Select the action in the Actions field, set the extended
parameters, and click the Single button to perform the action.
All instruments must be connected by GPIB cables before starting the system setup.
Device Parameters
None
Test Parameters
The following parameters must be set to perform the system setup.
DcSwitch Set Yes to use the pulse/dc switch. Do not set No.
Actions Actions available for the pulsed IV system setup.
• System Configuration
• Compensation
• Skew Measurement
• Drain Cable Replacement
• Pgu Compensation
For the actions, see “Pulsed IV System Setup” on page 3-3 .
Extended Test
Parameters
Set the switch controller GPIB address to the SWAddress field. The other fields are
only for the Pgu Compensation action.
SWAddress GPIB address of the switch controller. Integer, 1 to 32.
PulseBase Only for Pgu Compensation. PGU output baseline voltage.
-
3.0
to 3.0 V, 4 digits or 10 mV resolution.
TransTime Only for Pgu Compensation. Pulse leading/trailing edge
transition time, in s. 2 ns to 500 ns, 3 digits or 1 ns resolution.
For the 81101A, minimum value is 5 ns.
For the 81150A, minimum value is 2.5 ns when the following
conditions are satisfied, or 7.5 ns.
• Pulse amplitude is 2.5 V or less.
• Both pulse base and top are within

2.5 V.