A
EPM Series Power Meter (E4418B) Modification
74
Keysight 8480 Series Operating and Service Manual
The Material and Tools Required
The following material and tools are required for this modification:
– A T-15 torque screwdriver.
– A Razor blade or Craft Knife.
– Three 30 cm lengths of AWG 20 single core wire.
– Three screw-fit BNC Female connectors
(Keysight Part Number 1250-0118).
– A fine tip marker pen and adhesive labels.
– A 10-20 Watt pencil tip soldering iron.
– 60/40 0.8 mm rosin activated core solder wire.
– A Wire stripper.
– 25 lb/in Torque Wrench - Size 7/16 in. AF.
Impact on Warranty
NOTE
Please be aware that doing this modification requires you to open the power
sensor. Therefore, as stated earlier, any attempt to disassemble the power
sensor will void the warranty.
Summary of Contents for 8480 Series
Page 1: ...Keysight 8480 Series Coaxial Power Sensors Operating and Service Manual...
Page 58: ...3 Service 58 Keysight 8480 Series Operating and Service Manual Figure 3 1 Schematic diagram...
Page 93: ...Bulkhead Assemblies B Keysight 8480 Series Operating and Service Manual 93 Figure B 4 8481D...
Page 95: ...Bulkhead Assemblies B Keysight 8480 Series Operating and Service Manual 95 Figure B 6 8483A...
