Keysight Technologies 11713D, Operating And Service Manual

Page: 30 / 105

2 Installation
30 Keysight 11713D/E Operating and Service Manual
Table 2-2 11713D/E front panel and back panel properties
Front panel pushbuttons
[a]
[a] The ON/OFF status of the pushbutton LEDs indicates which cable wire or pin on the rear panel connector is grounded. As an example, if
ATTENUATOR X pushbutton 3 is illuminated, pin 10 of the ATTEN X connector (blue wire from cable) is grounded and pin 9 floats at a high
impedance. For solid state switches (P and U series switches), pin 3 is NC (No connected), pin 4 is connected to -5V, regardless of
whether pushbuttons 9 and 0 LEDs are ON or OFF.
Vcc will auto reset to 5V and TTL mode will automatically turn on for rear panel connector pins 5, 7, 9 and 11.
Rear panel connectors
Pushbutton number
Pushbutton
LEDs
Pin numbers
Wire color code
[b]
[b] With reference to interface cable option 201 (Viking connector to 12-pin bare), consists of 12 color-coded wires
1 Red (Vcc)
2 White/Brown (Gnd)
X
9
ON ATTEN X-3 (S9-A) Gray
OFF ATTEN X-4 (S9-B) White/Red
Y
0
ON ATTEN Y-3 (S0-A) Gray
OFF ATTEN Y-4 (S0-B) White/Red
ATTENUATORS
X Y
1 5
OFF 5 Violet
ON 6 Yellow
2 6
OFF 7 Black
ON 8 Green
3 7
OFF 9 Orange
ON 10 Blue
4 8
OFF 11 Brown
ON 12 White