Keyline NINJA LASER, Use And Maintenance Manual

Page: 46 / 172

E
N
GLISH
18 Keyline S.p.A. NINJA LASER Man. cod. B409927FG Copyright by Keyline - Italy
MODIFY AND CUT
7Modify and cut
7.1.0 Decode
This function makes it possible to decode a sample key after search-
ing for it with one of the methods described in the previous para-
graphs.
Warning: Important!
It is not possible to decode painted keys or keys made
of non-conductive materials.
How to proceed:
• From the key search sub-menu, select “ ”.
• Insert the original key in the jaws and lock it in place.
• Then follow the instructions on screen until the end of the
decoding process.
7.2.0 Code
This function makes it possible to input a specific code contained in
the data base and obtain the relevant coding.
How to proceed:
• From the key search sub-menu, select “ ”.
• Input the blind code.
• Then press
►
” to go to the following screen, the key “CUT-
TING” one (for additional information, please refer to para-
graph 7.5.0 on page 19).
7.3.0 Direct
This function makes it possible to insert the bitting code for the key
directly.
How to proceed:
• From the key search sub-menu, select “ ”.
• Input a value for each cut that shall correspond to the bit-
ting code.
• Then press
►
” to go to the following screen, the key “CUT-
TING” one (for additional information, please refer to para-
graph 7.5.0 on page 19).