TA7004NT TimeAttendance Terminal User Manual V1.00
22
3.4.4.
Clear all
If somehow the entire data, time, password or work mode is messed up, we can
use Clear All to reset the controller to defaulted state.
1.
Select initial
2.
Select clear all
Press # again to confirm Clear All and all configuration will be set to defaulted.
3.5
Application Mode
1.
By Card
Steps: 1. Register your card by using Add Card in the manage menu. 2. Flash the
card on TA7004NT. (3-10cm read range) 3. The screen shows card number,
owner name. 4. Relay responds, door open.
Please note that if the card is not registered, the TA7003NT will beep three short
sounds and shows invalid card on the screen. Door will stay closed.
2.
By card + PIN
Steps: 1. Register your card and set password by using Add Card in the manage
menu. Password is limited to 4 digits. 2. Flash the card on TA7004NT. (3-10cm read
range) Input your password after a long beep sound and press # to confirm. Password
should be inputted in 8 seconds after flashing your card.
Clear Event
Clear card
Door Para init
Clear All
◆
Clock Setting
Card Setting
System
Initial
◆
