2.
Initial system startup
The system is programmed using SecuriProx Studio software (included in the
package). In order for the key storage system to initially connect to the SecuriProx Studio
server, you must set the IP address of the device, the server's IP address and other
network parameters on the key storage system.
To enter the initial settings mode, press the Settings button on the battery charging
module (located inside the main unit from the right side). On the tab "IP settings" it is
necessary to set the IP address of the device, the IP address of the server, and other
network parameters. The default port of the server is 8000. If this port is already
occupied on the server, then it is possible to change it. In this case, you must also change
the port number and on the server itself. See the installation instructions for the
software. To apply the changed settings, you must save them and reboot the device.
