Key Automation SEL3, Instructions And Warnings For Installation And Use

Page: 9 / 24

1 - SAFETY WARNINGS EN
3 - PRELIMINARY CHECKS
WARNING - for the safety of people, it is important to observe these instructions and keep
them for future use.
Read the instructions carefully before installation. The design and manufacture of the devices which
make up the product and the information contained in this manual comply with the current safety
standards in force. However, incorrect installation and programming can cause damage to property
and injury to persons who carry out the work and those who use the system. It is, therefore, important
to carefully follow all the instructions given in this manual during installation.
WARNING - before installing the product, verify and check the following points:
•
Check that the surface on which the device will be fixed is solid and does not vibrate
•
Use suitable electrical connections for the current required
•
Check that the power supply complies with the values of the technical specifications
•
Disconnect the power supply before installing
•
Make sure there is a circuit breaker in the power supply system with a distance between the contacts
that allows for total disconnection under the conditions laid down by overvoltage category III
2 - INTRODUCTION TO THE PRODUCT
DIGITAL RADIO SELECTOR FOR AUTOMATIC DOORS LEVANTE
The SEL3 Digital Selector is a device for radio control of automatic doors. Communication with the
CTLEV control unit takes place through the RXLEV receiver that must be inserted in the appropriate
CN9 connector. Up to four SEL3 selectors can be matched.
4 - PROGRAMMING
There are 8 blue LEDs that indicate the status of the automatic door, 2 red LEDs for reporting errors, a
yellow LED for signalling the low battery and a button for selecting the states and possibly for resetting
the CTLEV card.
4.1 DIGITAL SELECTOR LAYOUT
BUTTON
LEDs
BLUE
YELLOW
LED
LEDs
RED
DIP-SWITCH
DIP4 is not used
GREEN LED
YELLOW
LED
RED LED
BUTTON P2
ON
1 2 3 4
+
LOCKED PHARMACY FREE DELAYED BLOCK
INTERNAL RADAR BIDIRECTIONAL EXTERNAL RADAR OPENING PARTIAL
NOTES: To select the radio channel, the receiver and selector DIP-Switches must be in the same position.
Setting the DIP3 of the selector to ON enables the display of the selector activity; a periodic flashing
of the GREEN led and the RED led will be visible if there is a radio transmission. Factory DIP3 is set
to OFF.
Setting the receiver's DIP3 to ON will activate the continuous BEEP acoustic signal for errors; at the
factory the DIP3 is set to OFF (single signal).
CHANNEL DIP-SWITCH 1 DIP-SWITCH 2 FREQUENCY MHZ
0
OFF OFF
868.32
1
ON OFF
868.92
2
OFF ON
869.52
3
ON ON
869.85
SELECTOR LED SIGNAL DIP-SWITCH 3
DISABLED
OFF
ENABLED
ON
RECEIVER BEEP DIP-SWITCH 3
SINGLE
OFF
CONTINUOUS
ON
4.2 RADIO CHANNEL SELECTION
4.3 SELECTOR ACTIVITY DISPLAY
4.4 BEEP ACOUSTIC SIGNAL OF THE RECEIVER
4.5 DIP SWITCH LEARNING
DESCRIPTION EXAMPLE BEEP
Press and hold selector button P2 for 1 second
P2 > 1 s
Wait for the green LED of the selector to turn on
GREEN
Release button P2.
The selector will learn the DIP SWITCHES