MY20K10 - 12_1.0_11.01.2021
99
Troubleshooting, fault clearance and repair
9.1.7
Other errors
Symptom
Cause
Remedy
Two beeps will sound if a
switch is pressed but the
switch cannot be
operated.
Pressed switch mode has been
deactivated.
This is not a malfunction.
Three beeps are
sounded.
A fault or warning has occurred. This
occurs when an error message is
displayed.
Follow the instructions for the code indicated on the display
screen in Section 6.2 System Messages.
When you use an
electronic gear shift, you
can feel that pedal
assistance becomes
weaker when the gear is
changed.
This is because the on-board computer
sets the pedal assistance to the
optimum level.
This is not a malfunction.
A noise can be heard
after switching.
Contact your specialist dealer.
It is normal to hear a
noise coming from the
rear wheel when cycling
as normal.
The gear shift setting may not have
been made properly.
Contact your specialist dealer.
If the S pedelec stops,
gear transmission does
not switch to the position
pre-configured in the
functional feature.
You may have applied too much
pressure on the pedals.
It is easier to change gears if you press onto the pedals gently.
Table 39: Error solution for battery
