MY20K10 - 12_1.0_11.01.2021
70
Operation
6.13.3.1
Charging on the S pedelec
The drive system will switch off automatically
after ten minutes when not activated if the
S pedelec battery is not charging. The on-board
computer battery will also stop recharging in such
a case.
The on-board computer will only charge when
switched on.
1
Switch on-board computer on.
2
Place on-board computer in its mount.
The charging process starts automatically.
6.13.3.2
Charging using the USB port
The on-board computer will only charge when
switched on.
1
Switch on-board computer on.
2
Open USB protective flap.
3
Connect a standard USB charger (not included
in the standard scope of delivery) to the USB
port on the on-board computer (5 V charge
voltage; max. 500 mA charging current) using
a micro USB cable or to the USB port on a
computer.
The charging process starts automatically.
If the on-board computer is switched off during
recharging, it cannot be switched on again until
the USB cable has been disconnected.
6.13.3.3
Switching on the on-board
computer
Figure 77: Position of On-Off button (on-board computer)
Press the
On-Off button (on-board computer)
briefly.
The electric drive system is switched on.
6.13.4 Switching off the on-board
computer
If the on-board computer is not inserted into its
mount, it will switch off automatically after one
minute to save energy if no button is pressed.
Press the
On-Off button (on-board computer)
briefly.
The electric drive system is switched off.
6.13.5 Lock (premium function)
The lock function can be purchased under the
<Shop> tab in the eBike Connect app. Once the
lock function is switched on, the e-bike drive unit
assistance is deactivated by disconnecting the on-
board computer. It can then only be activated
using the on-board computer belonging to the
e-bike.
You will find detailed instructions in the online
operating and maintenance instructions at
www.Bosch-eBike.com/en/Kiox-manual
.
1
