MY20K10 - 12_1.0_11.01.2021
41
Assembly
4
Press to push the battery cover onto the
battery. In doing so, ensure that the battery
On-Off switch fits through its designated slot in
the cover.
Figure 35: Pushing the battery cover onto battery
The battery cover will lock into the fitting
grooves on the battery.
The battery can now be inserted into the frame.
5.5
Preparing the on-board computer
The on-board computer is delivered with a
partially charged rechargeable battery. Charge
this battery via the USB port or the system for
at least one hour before it is used for the first
time.
Attach the control panel in such a way that the
buttons are almost vertical to the handlebars.
Set the language when you first put it into
operation.
5.5.1
Installing the wheel in the Suntour
fork
5.5.1.1
Screw-on axle (15 mm)
Only applies to Suntour forks with 15 mm screw-on axle
1
Insert the axle completely on the drive side.
Figure 36: Fully inserting the axle
2
Tighten the axle to 8–10 Nm with a 5 mm
hexagon socket spanner.
Figure 37: Tightening the axle
3
Insert the securing screw on the non-drive
side.
Figure 38: Pushing the quick release lever into the axle
4
Tighten the securing screw with a 5 mm
hexagon socket spanner to 5–6 Nm.
The lever is mounted.
Figure 39: Tightening the securing screw
