Kersten WKB 60 M-U 70, Original Operating Manual

Page: 11 / 19

English
11
4 disposal
The devices must be disposed of according to the applicable regulations of the municipality, the
city or the country.
Depending on the material, the parts may be recycled, recycled, or recycled. Kersten UK (LTD)
does not accept any disposal.
5 guarantee
The device is accompanied by a sales message which, among other things, specifies the date of
commencement of the warranty period. When selling the device, please fill out the sales message
completely and send it back to us within 14 days. If warranty claims are asserted, without a sales
message, we will not process warranty claims.
Warranty claims should be submitted promptly, but at the latest six weeks after the occurrence of
damage, under the terms of the purchase data, otherwise no warranty processing will be carried
out. Complaints must be confirmed by Kersten UK (LTD). Wear parts are excluded from the
warranty. In addition, the guarantee will be void if the device is not used properly, if the device is
not used or if the device is not used properly, if the device is not used and if the device is not used.
6 description
6.1 General description of the weed brush
The weed brush consists of a steel construction with an angular gear on which the tool holder,
also known as a brush plate (1: F), is mounted. The brush plate can be equipped with a tuft
(1: H) or with wire rope braids. The weed is scraped out of the joints by the rotation of the brush
holder and the propulsion of the carrier vehicle and is absorbed by a laterally applied protective
device (1: E).
7 Assembly
1. Observe the information in the operating instructions of the carrier vehicle!
2. There is a risk of injury when coupling. Through bruises. Special caution is advised!
3. For the assembly of the attachment unit, the connection between the attachment unit
(2: A) and the two-wheel tractor (2: K) must be free of grease and grease.
4. The operation of the attaching unit without the plastic coupling dog (2: I) leads to
serious damage and is strictly forbidden.
5. When coupling the attachment unit, proceed as follows:
1. Turn off the engine.
2. Raise the locking lever (2: J) and fold the lever upwards for locking.
3. Move the pickup mandrel from the attaching unit (2: A) and the pick-up pin
from the single-axle tractor (2: K) to the same height to allow them to collapse.
4. Ensure that the coupling holder (2: I) is between plastic and the plastic.
6. If the receiving mandrel from the attachment unit (2: A) can not be pushed completely into
the pick-up tube by the one-axis tractor, the teeth of the two coupling halves may be
against one another. By switching on the auxiliary drive and by pulling slowly on the starter
cable of the motor, a clutch half rotates further and allows further pushing in.
1. Fold down the locking lever (2: J) and check that the locking pin is fully engaged.
2. To prevent twisting of the attachments, the star handles (3: L) must be tightened
against the chassis by the single-axle tractor and countered with the clamping lever
(3: R).