Kerotest Manufacturing
–
SHANNON & PAF III OPERATORS MANUAL - REV 3
Page 24 of 60
Pressing and holding down the
UP button
while the processor is at the CONNECT FITTING screen will show a
screen similar to the following:
1.2.3 SN:9690123
SW: ON 03 FC:0124
05/11/2018 15:30
CAL DUE
–
05/11/2021
This screen shows the following information:
•
Software version of the processor (In this case, version 1.2.3).
•
Processor serial number (In this case, 9690123).
•
SMART Scanner™ status (In this case,
ON).
•
The number of fusions the processor has completed (In this case, 124).
•
The Date and Time (In this case, May 11, 2018 at 3:30 PM)
•
The date the processor will be due for calibration (In this case, May 11, 2021)
Release the
UP button
to return to the CONNECT FITTING screen.
To begin the fusion process, follow the instructions in the following section that corresponds to the fusion
method that you wish to perform.
Barcode Fusions
**The Barcode Fusion Method is always preferred and should be used whenever possible.
When beginning a Barcode Fusion, start from the CONNECT FITTING screen.
Secure the correct fitting adapters
to the
Output Lead Ends.
Connect both
Output Lead Ends
to the fitting.
When the
Output Lead Ends
are connected to the fitting, the processor will measure the fitting resistance and
display a screen similar to the following:
VERIFYING
RESISTANCE
10.198
After measuring the fitting resistance, the processor will display the following screen:
SCAN BARCODE
