Wirnet iBTS
Document title : Installation and
Maintenance Manual
Version : 2.0
Author : SNI
Date : 04/12/2018
Classification
This document is the strict property of Kerlink and shall not be either copied nor sent without express
written authorization of Kerlink
Internal Use
Kerlink m2m technologies reserved rights
Confidential
Kerlink – 1 rue Jacqueline Auriol – 35235 THORIGNÉ-FOUILLARD
Page 44 / 221
Strict confidential
1.5.2.1
Connectors and user interfaces
The WAN module includes the following user interfaces and connectors:
Module side
Connector / interface
Description
Front side
WAN RF connector
WAN 4G RF signal to be connected to the LTE
antenna (internal or external)
Front side
USIM connector
Push-push connector
Insert USIM according to the besides picture
Right side
Back panel HE10 male
40 contacts connector
Transmit the power supplies and high speed
serial bus to the next module
Left side
Back panel HE10 female
40 contacts connector
Receive the power supplies and high speed
serial bus from the previous module
Figure 20: Connectors and user interfaces of the WAN module
Note:
UFL to SMA coaxial cables are used to connect the Mini PCI Express card to the
antennas.
