Wirnet iBTS
Document title : Installation and
Maintenance Manual
Version : 2.0
Author : SNI
Date : 04/12/2018
Classification
This document is the strict property of Kerlink and shall not be either copied nor sent without express
written authorization of Kerlink
Internal Use
Kerlink m2m technologies reserved rights
Confidential
Kerlink – 1 rue Jacqueline Auriol – 35235 THORIGNÉ-FOUILLARD
Page 171 / 221
Strict confidential
Another slot is available. It can be used for cable ties to tighten the RF coaxial cable to the
antenna bracket.
Note 1:
the M4 screws, the metallic strapping are not provided by KERLINK.
Note 2:
the cables ties are not provided by KERLINK.
Note 3:
the notched V shaped plate and a U-bolt can be provided by KERLINK as accessories
(see §6).
Once the dome antenna bracket is installed, then the GPS antenna, or LTE, or GPS/LTE
combo antenna can be mounted on the bracket. These antennas are provided with N female
connector(s) and a M22 nut.
Follow the following procedure:
Introduce the N connector(s) into the hole of the bracket
Pass all the coaxial cable length through the hole until the antenna is in contact with
the bracket
Unscrew the M22 nut
Introduce the antenna M22 screw into the hole
Beware the position of the gasket to insure waterproof installation. There must be no
aperture between the antenna casing and the gasket.
Screw the M22 nut
Repeat the operation for GPS antenna, LTE antenna (or GPS/LTE combo antenna).
Figure 107 : N connector introduced in the hole of the dome antenna bracket
Figure 108 : Antenna installed on the dome antenna bracket
M22 nut
Gasket
