Kerio Tech Firewall6, Administrator'S Manual

Page: 83 / 404

7.3 Definition of Custom Traffic Rules
83
Figure 7.16
Traffic rule — NAT — NAT with specific interface (its IP address)
any other address is used (including even local private addresses). NAT will not
work correctly and packets sent tto the Internet will be dropped.
•
For obvious reasons, specific IP address cannot be used for NAT in the Internet
connection failover and the network traffic load balancing modes.
Figure 7.17 Traffic rule — NAT — NAT with specific IP address
Full cone NAT
For all NAT methods it is possible to set mode of allowing of incoming packets coming from
any address — so called Full cone NAT .
If this option is off, WinRoute performs so called Port restricted cone NAT . In outgoing packets
transferred from the local network to the Internet, WinRoute replaces the source IP address of
the particular interface by public address of the firewall (see above). If possible, the original
source port is kept; otherwise, another free source port is assigned. As to incoming traffic,
only packets sent from the same IP address and port from which the outgoing packet was sent