KharkovEnergoPribor Ltd. | KEP Ltd.
+380 57 393 1069
www.kep.ua | [email protected]
12
USER MANUAL
4.3.3
In the MEASUREMENTS submenu you may use the following
options (see Figure 3g):
the AUTO, H and I options
– to switch ON/OFF the continuous
indication of utility depth (
«H») and the current flowing through the
utility line («I»);
FREQUENCY SET option
– to set the frequency levels for further
shortcut selection with the «F» button (see Figure 3h). You may
enter the frequency levels into the list of available values or delete
them with the “H” button. You may exit with the MENU button.
4.4 Operating Modes
4.4.1
The Tracer operates in two modes:
TRACE
– to locate the utility and detect its depth and operating
frequency current flowing through it. The display of this mode is
shown in Figure 4a;
TRACE-SONDE
– to locate the utility insulation damage and
detect the depth of damaged area; to detect the short-circuited
areas or wire break and select the conductors in the multi-core
cables. The display of this mode is shown in Figure 4c;
with the COMPASS option switched on, the direction of the
located cable relative to the Tracer will be displayed. The display
of the TRACE mode with COMPASS.
feature is shown in Figure 4b; in the TRACE-SONDE mode
– in
Figure 4d.
To exit the TRACE mode and enter the TRACE-SONDE mode (and
vise versa), press the MODE key and hold it pressed for more than
two seconds.
WARNING!
For the correct operation of the Tracer in the TRACE-SONDE
mode, use the A-frame of new version with insulation joint.