Assembling Base
Texan Stand
1
Assemble stand on a carpet or soft surface
to avoid any dents or scratches.
Kenyon has done our best to deburr the sheet
metal, but it can still be sharp, please be
mindful when assembling this stand. We
recommend using gloves.
Please leave vinyl on parts until finished
assembling. The vinyl has been removed from
joining faces but the outer faces will continue
to have some protection.
Unpack stand parts carefully, lay the parts out
to check for shipping damage.
Instructions
7
2
Place 2 Legs on the ground, vinyl side
down. All of the legs are the same. The legs
have holes throughout the length of them.
Place the Front Frame, vinyl side down, and
align the top (3 holes with nuts) with the top
of the legs. Fasten together lightly, do not fully
tighten yet, Screw S1 to corresponding hole 1
and hole 2.
Use: Screw S1
There will be 4 included hooks in this package.
These use Very High Bond tape so first
adhesion is very important. Please thoroughly
clean the stainless steel where you want the
hooks to be. On the back of the hook there is
the double-sided tape. Peel the protective
layer off and then stick the hook on firmly.
Allow this to set for at least 2 hours before
putting any load on the hook.