4
Take this time to tighten all screws (don’t
forget under the shelves!).
Now, if assembling the Shelf Kit skip this step
and go to the next page. If not assembling the
shelf kit, place the Texan grill into the stand,
please be careful, 2 people recommended.
Hold by the strongest part of the flange as
close to the Texan body as possible. Be
aware, flange will bend if held too far out.
Fasten Texan to stand using Screw S2.
Use: Screw S2
If using the mounting brackets to fasten the
stand to the deck, find the install location to set
the Texan. There are two types of mounting
brackets, they are mirrors of each other. Use
screw S3 to fasten to the deck or patio.
Use: Screw S3
Take all of the remaining vinyl off and use
this time to clean and polish to put a beautiful
shine on the grill and stand’s stainless steel.
Remember to wipe
with
the grain, never
across or diagonally.
Instructions
10
Continue to the next section
to assemble the shelf kit.
Assembling the Shelf Kit
1
Now, we are going to fasten the handle to
the shelf. Take one S1 screw, put it through
the hole on the underside of the Side Shelf.
Repeat for each screw. Now, take the handle
assembly and easily fasten to the shelf!
Use: Screw S1
Hardware kit and accessories can be found
inside the rectangular packaging.
2
Use Screw S1 to fasten the Side Shelf to
whichever side of the stand makes the most
sense for your application.
Use: Screw S1
3
The shelf can be lifted into position by
lifting the handle, reaching under and pulling
the wings of the shelf to a right angle with the
stand. There are two sets of two rubber bum-
pers under the shelf that the wings will align in
between them. This will mitigate any chance
of the wings being moved while the shelf is up
and will also be softer when putting the shelf
down.
4
Congratulations all Texan stand kits have
been assembled! Take this time to tighten all
screws (don’t forget under the shelves!). Now,
place the Texan Grill into the stand, please be
careful, 2 people recommended. Hold by the
strongest part of the flange, as close to the
Texan body as possible. Be aware, flange will
bend if held too far out. Fasten Texan to stand
using Screw S2.