Kenwood TS-990S, Instruction Manual

Page: 250 / 290

16 USEFUL FUNCTIONS
16-18
Index Contents
CONFIGURING THE RESOLUTION OF THE
EXTERNAL MONITOR
You can configure the resolution of the external monitor
connected to the DISPLAY connector.
1 Press [ADV.] (F) from the Menu screen to open the
Advanced Menu screen.
2 Access Menu 26, "Resolution (External Display)".
3 Press [SELECT] (F4) to allow editing of the parameter
box.
4 Press [-] (F4) or [+] (F5) to select the resolution.
Available parameters are "800x600" and "848x480". The
default is "800 x 600".
5 Press [ ] (F1).
6 Press [MENU] to exit.
Note:
◆ If you change the resolution of an external monitor, the display may
disappear until the changed configuration will be applied.
DISPLAYING THE MAIN SCREEN
CONTENTS ON AN EXTERNAL
MONITOR
If you connect an external monitor to the DISPLAY
connector, you can display the main screen image on the
external monitor as well.
[F1]~[F7]
[MENU]
F[ADV]
1 Press [ADV.] (F) from the Menu screen to open the
Advanced Menu screen.
2 Access Menu 25, "External Display".
3 Press [SELECT] (F4) to allow editing of the parameter
box.
4 Press [-] (F4) or [+] (F5) to select "On".
The default is "On".
5 Press [ ] (F1).
6 Press [MENU] to exit.
Note:
◆ Connect the transceiver with an external monitor using a
commercial available DVI cable.
◆ Depending on the specifications of the external monitor, the display
cannot be traced correctly when the transceiver power ( ) turns
ON.
◆ To enter the video signal to an external monitor using the VGA
connector, use the commercially available DVI analog conversion
adapter.