Kenwood TS-990S, Instruction Manual

Page: 169 / 290

9-1
9 TRANSMIT FUNCTIONS
Index Contents
SELECTING THE AUDIO LINE FOR
TRANSMISSION
There are audio lines to input the audio signal for
transmission to the transceiver. According to your
operating mode, you can select the audio line to enter the
audio signal.
Location Modulation Source Overview
Front Panel MIC
With “MIC” enabled, the voice signal
spoken into the microphone is
sourced to the transceiver.
Rear Panel
ACC2
With ACC 2 enabled, the audio signal
sourced from the device connected to
the ACC 2 connector is processed.
(USB-B)
With the USB Audio enabled, the
audio signal from a PC is sent to the
transceiver.
OPTICAL IN
With OPTICAL enabled, the audio
signal from the audio device with the
optical digital terminal.
In SSB, USB, FM, FMN and AM modes, each press of
[DATA/SEL] cycles through “Off” > “Data 1” > “Data 2” >
“Data 3” > “Off”, and three audio lines for the audio source
can be configured.
SELECTING THE AUDIO SOURCE FOR
TRANSMISSION BY SEND/PTT
The audio sourced from the MIC connector on the front
panel of this transceiver or from the ACC 2, (USB-B),
OPTICAL IN connectors can be configured for each
transmit method.
• The audio modulation source when the front panel [SEND] or
the PTT (microphone) switch is pressed
• The audio modulation source when the PF key for which
"DATA SEND" was configured in Menu 0-15, "PF A:
Key Assignment" to Menu 0-32, "Microphone UP: Key
Assignment" is pressed
[DATA/SEL] [F1]~[F7] [ESC] [MULTI/CH]
SELECTING THE AUDIO SOURCE TRNASMISSION BY
SEND/PTT
The audio sourced from the MIC connector on the front
panel of this transceiver or from the ACC 2, (USB-B),
OPTICAL IN connectors is transmitted upon a press of
[SEND] or the PTT (microphone) switch is pressed.
1 Press and hold [DATA/SEL] to open the Modulation
Source screen.
2 Press [ ] (F2) or [ ] (F3) to select
"SEND/PTT".
3 Press [ ] (F4) or [ ] (F5) to select the
audio source.
You can select the audio source to transmit when [SEND] or
the PTT (microphone) switch is pressed.
4 Press [ON/OFF] (F5) to enable the audio source.
The following table shows the default settings.
Status of DATA
Mode
Modulation Source
MIC ACC 2 USB Audio OPTICAL
DATA Off On Off Off Off
DATA 1 to DATA 3 On Off Off Off
5 Press [ESC], or press and hold [DATA/SEL] to exit.
Note:
◆ The audio signal from the audio source will be transmitted by a
press of [SEND] on the front panel or the PTT (microphone) switch.
◆ Both USB Audio and ACC 2 cannot be enabled at the same time.
Enabling one will disable the other.