Kenwood TKR-750, Programming Reference Manual

Page: 63 / 83

Version: 1.01 Field Programming Reference (FPRG) 58
6 EDIT MENU
6.15 Embedded Message w/
Password Window
It can configure a message and a password into the TKR-
750/850/751/851 on the “Embedded Message w/
Password” window. You can configure a message with up
to 64 characters (combination of alphabets and numerals)
to the repeater. You can also configure the password to
protect the message. You can embed the specific
information in it, such as the control number or the name of
the configuration data written with a password.
Figure 6-24 “Embedded Message w/Password” window
Directly enter the message in the edit box.
"
Write Button
This can write the configured message into the TKR-
750/850/751/851.
Follow the procedures below to write the message.
1. Click “Write”.
The Password Entry display appears.
Figure 6-25 Password Entry display
Note: The display requiring you to configure the password
when the password is not configured. You must
configure the password first, then you can write the
configured message.
2. Enter the password and click “Write”.
3. Click “OK”.
Note:
!
The error message appears if you enter an incorrect
password.
!
The password entry display closes when entering a wrong
password three times in a row.
!
When writing the message with Embedded Message w/
Password, you can store the message as a separate data
from the configuration data.
"
Password Button
It can configure the password and change it.
Follow the procedures below to configure/change the
password.
1. Click “Password”.
The “Caution” window appears. Click “OK” to view
the “Password Change” window.
Figure 6-26 “Caution” window
Figure 6-27 “Password Change” window
2. Enter the password.
You can configure a password a maximum of 6
characters.
Old Password: Enter the old password in this box.
New Password: Enter the new password.
Confirm: Enter the same password as the “New
Password” to confirm.
3. Click “Write”.
4. Click “OK”.
Note:
!
The error message appears when the password entered in
the “Old Password” box does not match with the registered
password.
!
The error message appears when the password entered in
the “New Password” box does not match with the password
entered in the “Confirm” box.
!
The password entry display closes when entering an
incorrect password three times in a row.
Range Maximum of 64 characters and symbols.
Default Blank