Kenwood TK-D240, Service Manual

Page: 46 / 64

1-46 (No.RA035<Rev.001>)
SECTION 5
TROUBLESHOOTING
5.1 Replacing Main Unit
 Main unit Information
 Supplied Accessories of "Service Main unit"
 “Service Main unit” Data
The following data is written on the service Main unit:
 After Changing the PCB
(1) Using the KPG-166D, select your desired item (Model
Name and Frequency) from the Model> Product Infor-
mation menu, then use Program> Write Data to the
Transceiver to write the FPU data (PC Programming
mode). When writing to the transceiver, a Warning Mes-
sage, corresponding to the item selected, appears. Click
[OK] to continue writing the data.
(2) Enter Program> Test Mode, then adjust the various ad-
justment data (PC Test Mode) as described in the “SEC-
TION 4 ADJUSTMENT" .
(3) If necessary, write the FPU data used by the customer
with the KPG-166D.
Note:
• When a new printed circuit board is used, the KENWOOD
ESN changes, as does the Transceiver Information dis-
play of the KPG-166D, but this does not have any effect
on the operation of the transceiver.
• If changing to the original ESN, please contact our service
center.
Model Name Original Main unit
Number
Service Unit
Number (XCA-***)
TK-D240 K XC1-1162-70 XCA-001E-00S
(Main Unit Number:
XC1-1162-71)
TK-D240 M XC1-1162-70 XCA-001E-00S
(Main Unit Number:
XC1-1162-71)
TK-D240 E XC1-1162-70 XCA-001E-00S
(Main Unit Number:
XC1-1162-71)
TK-D240 E2 XC1-1162-70 XCA-001E-00S
(Main Unit Number:
XC1-1162-71)
TK-D240V K XC1-1162-70 XCA-001E-00S
(Main Unit Number:
XC1-1162-71)
Item (Including Parts Number) Quantity
Main Unit (XC1-1162-71) 1
Data Type Description
Firmware TK-D240/D340 Firmware
FPU Data
(PC programming
mode) XC1-116 (TK-D240) E type data.
KENWOOD ESN Model name: TK-D240
Type: E
The same number as a the Model Name
Plate label is written.