TK-5210
(
G
)
14
DISASSEMBLY FOR REPAIR
4. Pass the volume, channel switch, VOL/CH FPC and
CONTROL-TOP FPC through hardware fixture holes,
then bring the hardware fixture into contact with the
chassis and fi x it with a screw
t
.
Note:
The projections of the volume and channel switch ped-
estals must protrude from the square holes of the hard-
ware fi xture.
5. Fix the antenna receptacle with the two screws
y
.
6. Fix the hardware fi xture with a screw
u
.
=
B
>
7. Insert the VOL/CH FPC
i
and the CONTROL-TOP FPC
o
. into the connectors (CN902, CN903) of the TOP PCB.
8. Fix the TOP PCB with a screw
!0
.
9. Fix the TOP PCB with a screw
!1
.
CN902
CN903
2
8
■
TX-RX PCB Installation Procedure
1. Insert the coaxial cable of the antenna receptacle into the
coaxial connector (CN101) of the TX-RX PCB
q
and the
coaxial cable of the ANT PCB into the coaxial connector
(CN102) of the TX-RX PCB
w
.
2. Grasp both sides of the lower part of the TX-RX PCB, tilt
the TX-RX PCB and install the chassis so that the PTT
FPC
e
, CONTROL-TOP FPC
r
and universal connector
FPC
t
are not caught
y
.
3. Fix the TX-RX PCB with the 14 screws.
CN102
CN101
.
;
B
=
:
@
■
LCD ASSY Installation Procedure
1. Fold the LCD ASSY FPC to the back of the holder
q
so
that the FPC is between the two tabs on the right side of
the holder
w
.
LCD ASSY FPC
tab
tab
:
@
Sheet
Sheet
2. Fit the two tabs on the right side of the holder
e
and the
two tabs on the left side of the holder
r
into the CON-
TROL PCB.
Note:
Take care that the FPC is not caught when fi tting the two
tabs on the right side of the holder.
tab
CONTROL PCB
;
;
.
.
3. Insert the FPC into the CONTROL PCB connector (CN1)
t
.
CN1
=
