60
VOX DELAY TIME
If the transceiver returns to receive mode too quickly after you stop speaking, the
end of your message may not be transmitted. To avoid this, select an appropriate
delay time that allows your entire message to be transmitted. However, do not
make the delay overly long.
1
Enter the Setting mode {p.37}.
2
Press the or button to select “
”.
3
Press the
Menu
button then press the or button to select your desired
value.
/ /
/ / /
0.1/ 0.3/
0.5/ 1.0/
1.5/ 3.0
During transmission, from 0.1 seconds to 3.0 seconds VOX
transmission will continue if there is voice input reaching
microphone sensitivity that operates VOX during the selected
time.
4
Press the
Menu
button to confirm the selection, then press the
PTT
switch or
the
Side
button to return to the operation mode.
TRANSMIT INHIBIT WHILE RECEIVING
While using VOX, you can set the transceiver to detect when the channel is in use
(in place of using the Monitor function). With this function turned on, VOX will not
allow you to transmit while the channel is being used. You can transmit only when
the channel is free.
1
Enter the Setting mode {p.37}.
2
Press the or button to select “
”.
3
Press the
Menu
button then press the or button to select your desired
value.
OFF
Even if the channel is used, VOX will allow transmission.
ON
While the channel is being used, VOX will not allow you to
transmit.
4
Press the
Menu
button to confirm the selection, then press the
PTT
switch or
the
Side
button to return to the operation mode.
