Kenwood ProTalk NX-P500, User Manual

Page: 59 / 68

59
ENCRYPTION KEY DATA
Set the encryption key to be used with the Encryption function.
Refer to operate private talk using Encryption key data. {p.17}
1
Enter the Setting mode {p.37}.
2
Press the or button to select “ ”.
3
Press the Menu button then press the or button to select your desired
value.
~
1 ~ 32767 Select the your desired code from 1 to 32767.
4
Press the Menu button to confirm the selection, then press the PTT switch or
the Side button to return to the operation mode.
VOX SETUP
Note:
◆
To use the VOX function, you need to set the VOX function to "ON" in channel set mode
{p.33}.
VOX GAIN LEVEL
With VOX activated, your voice level will determine when you transmit. Due to
the automatic switching between transmission and reception, we recommend you
set the VOX gain level such that it will not activate when in an area with excessive
ambient noise.
1
Enter the Setting mode {p.37}.
2
Press the or button to select “ ”.
3
Press the Menu button then press the or button to select your desired
value.
~
1 ~ 10
Adjust so that the VOX function works reliably when talking into the
microphone.
If it does not work even when you speak, gradually increase the level.
• While adjusting the VOX Gain level, speak into the microphone. When
an appropriate level is reached, the LED lights yellow, but no signal is
transmitted at this time.
• Setting the VOX gain level to OFF deactivates VOX. In order to transmit
with VOX turned off, you must use the
PTT
switch.
4
Press the
Menu
button to confirm the selection, then press the
PTT
switch or
the
Side
button to return to the operation mode.