Kenwood DDX8020S, Instruction Manual

Page: 79 / 116

Controlling Audio
79
English
NOTE
• When the 3-way speaker system is selected, the
following functions are disabled.
– Front focus of Listening Position / DTA
– Fader for Controlling General Audio
– Zone Control
– Selection of the speakers to output sound from
the cell-phone of Bluetooth HF/Audio
– Beep for User Interface Setup
• Connecting 3-way speakers with the 2-way mode
selected can break the speakers.
• When the dual zone is selected and audio source
other than "OFF" is selected as Rear Source, the
speaker system cannot be switched.
Speaker / X’over setup
1
Press the
[
MENU
]
button.
h h Popup menu appears.
2
Touch
[
Audio
]
.
h h Audio screen appears.
3
Touch [
Speaker / X
ʼ
over
] .
4
Select a car type.
You can select the car type and speaker
network, etc.
When you select your car type, the Delay
Time Alignment is activated automatically
(for timing adjustment of sound output for
each channel) to have the highest surround
effects.
5
Touch the speaker (
1
) you wish to adjust
and set each parameter (
2
) as follows.
1
2
■ [
Speaker
]
You can select a speaker type and its size to
get the best sound effects.
When the speaker type and size are selected,
the speaker crossover network is set
automatically.
■ [
Location
]
(Only for Front, Rear)
Select the speaker position you have
installed.
■ [
Tweeter
] (Only for Front)
You can set up the tweeter when you are
selecting front speakers.
None, Small, Medium, Large
■
[
X
ʼ
over
]
Display the speaker crossover setup screen.
You can adjust the crossover frequency that
was set automatically when you selected the
speaker type.
For details, see
Crossover network setup
(P.80)
When Speaker network is set to 3-way:
1
2
NOTE
• For how to switch to the 3-way speaker system,
see 3-way speaker system setup (P.78) .
Connecting 3-way speakers with the 2-way mode
selected can break the speakers.
• Select “None” if you have no speakers.