22
Installing the router
If you are able to access the WAN, your initial router setup is complete. Refer to the
User’s Guide
for information on setting up advanced features.
Should the ping test fail, check to make sure you entered the correct IP address and
interface for the default gateway on the
Configure > Router > Routes
page. If they
appear to be correct, compare the settings on the
Configure > Interfaces > T1 Port 1
page with your configuration worksheet, and—if necessary—with the original
connection specifications from your WAN service provider or network
administrator. You should also verify the cable connection by checking to see that
the WAN STAT LED on the front panel is green.
If all else fails...reset
Should you encounter unexpected behavior after configuring the Kentrox router,
and you are unable to determine the cause, you can reset the router to its factory
default configuration.
To do this, either hold in the reset button on the router’s back panel for 12 seconds,
or go to the
Configure > System > System Restart
page in the interface and click the
“reset to factory defaults” check box. The reset button is recessed to prevent
accidental resets, so you will need a small pointed object, such as a pen or paper clip
end.
Additional troubleshooting information and documentation can be found on these
Kentrox web pages:
. A
list of factory default values is provided in the
Q-Series User’s Guide
.
Summary of Contents for q2200
Page 4: ...4 Contents...
