Page | 7
Save This Manual for Future Reference
ESD Electrical Circuit
Work Surface
A wire connects the conductive aluminum boot to a common ground located in worksurface. A
wire is connected from the common ground to an external Earth ground wire. A wire is
connected from the common ground to the wrist strap ground point.
Care and Cleaning
Painted Surfaces
All painted surfaces can be cleaned with a non-abrasive, non-ammonia or non-bleached based
cleaner. Do not use soap or detergents on exposed metal surfaces, leg levelers or on the work
surface. The soap may leave a residue that will insulate the surface from ESD grounding. Wipe
down all cleaned surfaces with a lint free soft cloth.
Leg levelers
Three of the four leg levelers are adjustable and non-conductive. They can be cleaned with any
non-ammonia or bleached based cleaner. The fourth Leg leveler is equipped with an aluminum
conductive boot. This can be cleaned with any non-ammonia or bleached based cleaner.
Approved cleaning solutions for ESD surfaces
•
Desco 10446 Reztore Surface & Mat Cleaner
•
3M 8001
Antistatic Mat & Table Top Cleaner
NOTE:
Do not use petroleum-based solvents or alcohol to clean any surfaces on this ESD
Workbench.
