Ken 59.480, Instruction Manual

Page: 36 / 44

Section/page:16.2
Parameters
KEN DW 412
Subject to alterations 17/9/2013
-adjustments of the machine, continued
Description
Adjustments
from factory Possible
adjustments
User adjustments
Heating rinse tank effect (W)
Indicates the size of the heating element in
the rinse tank. This adjustment is used for
estimating the consumption of energy and
validation of heating time, and by that
deciding if the heating element is defect.
9000 0-99999
Pump effect (W)
Indicates the size of the wash pump. This
adjustment is used for estimating the
consumption of energy.
850 0-99999
Detergent pump kapacity (ml/min)
Indicates the capacity of the dosing
pump. This adjustment is used for
estimating the consumption of detergent.
100 0-999
Standby time (min)
Indicates how many minutes it takes before
the machine automatically turns to standby
mode if it is not in use. When the machine is
not in standby mode, it will keep the wash
tank and rinse tank heatet. When the
machine turns to standby mode, it will turn
off the heat and the display light. If the time
for standby is set to 0, the machine will
never automatically turn to standby mode.
0 0-999
Alarm for changing filter (l)
An alarm will go when the machine has
consumed more water than the set
parameter, on condition of this value is
larger than 0.
0 0-99999
Time for pressing key, high pressure (sec)
Indicates how long the start key has to be
pressed to make the machine wash at high
pressure. This applies to both start key on
the keyboard and external start key.
0,5 0-99,9
Level sensor, low level
Sensitivity of the level sensor for measuring
the low water level. This parameter is as a
standard set to 50% and kan be changed if
detecting the low level is causing problems.
50% 0-100%
Level sensor, high level
Sensitivity of the level sensor for measuring
the high water level. This parameter is as a
standard set to 50% and kan be changed if
detecting the high level is causing
problems.
50% 0-100%