ProfCam by Ken-A-Vision
®
Ceiling DocCam™ II
Installation & Operation Manual
910-171-066
Troubleshooting
5615 Raytown Road • Kansas City, MO 64133 U.S.A.
Tel.: 816-353-4787 • Fax: 816-358-5072
email: [email protected] • www.ken-a-vision.com
Problem
Try this
No video image
The IR remote control
does not work
Can’t see an entire
drawing/page clearly
on the video screen.
Verify that the Cat. 5 is connected between the RJ-45 jack on
the back of the camera module enclosure and the RF-45 jack
on the back of the wall plate.
Make sure the provided 15 VDC power supply is plugged
into a wall outlet and the 15 VDC jack on the wall plate.
Check the S-video or composite cables to verify they are properly
connected, ensure video display device is powered and make
sure the display device is set to the correct video source
Verify fresh batteries are installed and positioned correctly.
Remove power supply plug from the 15 VDC jack on the wall
plate. Wait a few seconds and reinsert the power supply plug.
When large documents, such as blueprints, are being viewed,
the smallest details may not appear perfectly. The resolution
only allows zoomed in images to be clear. However, in viewing
normal size documents, details should be clear.
800-171-066
