Kemppi Minarc Mig Evo 200, Operating Manual, Page: 9 / 24

EN
Shielding gas
Shielding gas is used for replacing air around the welding arc. For steel wires, use CO₂ (carbon
dioxide) or a mixture of Ar (argon) and CO₂ for shielding gas. Welding performance will be
improved when using mixed gas products. For stainless steel wires, use mixture of Ar and
CO₂ (2 %), and for aluminium and CuSi wires, use pure argon. The required flow rate of the
shielding gas is determined by the thickness of the welded sheet and the used welding power.
The machine is delivered with a 4.5 m long gas hose. Connect the supplied female snap
connector of the gas hose to the machine’s male connector. Connect the other end of the gas
hose to the gas cylinder via a suitable and approved single stage regulator valve, where outlet
flow rates can be adjusted.
NOTE!
Never attempt to connect directly to a compressed gas cylinder. Always use an approved
and tested regulator and flow meter.
1.
2.
4.
l/min
5
10
15
20
3.
Connecting the gas hose to a typical welding regulator control valve
1. Connect the hose to the welding machine snap connector
2. Open the regulator valve of the gas cylinder
3. Measure the gas flow
4. Adjust the flow with the adjustment knob (10/15 lpm)
NOTE!
Use a suitable shielding gas for the welding application. Always secure the gas cylinder in an
upright position with either a specially made wall rack or cylinder trolley. Always close the cylinder
valve after welding.
7
M
inar
cM
ig E
vo 200 / © Kemppi O
y / 1110