Flexlite GC
Operating manual - EN
3.3 Installing and replacing wire liner
This replacement instruction
does not apply to Flexlite GC 223GMM
welding gun. For replacing the wire liner in Flexl-
ite GC 223GMM welding gun, refer to MinarcMig Evo operating manual.
The Flexlite GC MIG welding gun cable packs are delivered with the wire liner preinstalled. Refer to this section when
the wire liner needs to be replaced.
The wire liner is a consumable part, which needs to be changed if worn and when the filler wire material changes.
If you change the filler wire to a different diameter or material, change also the feed rolls accordingly.
Both steel spiral wire liner and DL Chili wire liner can be used.
The filler wire must be removed before the wire liner replacement.
Tools needed:
Removing and inserting wire liner
1.
Straighten the welding gun cable.
2.
At the wire feeder end of the cable, remove the wire liner's end cap, sleeve nut and retainer cone.
3.
If you are replacing an existing wire liner with a new one, remove the old wire liner from the cable hose.
If you still plan to use the same wire liner later, make sure not to damage the wire liner at this stage.
© Kemppi
9
1921860 / 2109