Operation
114
EVOLUTION LINE roll machine
Emil Kemper GmbH
7.4.6.4 Setting the timing adjustment
The cut is adjusted to the timing of the belt by moving the position of the cutting station. If
the setting is right, the cut is performed when the dough pieces are at a standstill.
Turn the adjusting wheel (1) in the direction of
the arrow (2) to move the cutting station to the
right.
Turn the adjusting wheel (1) in the direction of
the arrow (3) to move the cutting station to the
left.
7.4.6.5 Setting a recipe at the cutting station
Note!
The menu item 'Cutting station' can be accessed in the main menu of the
respective assembly after pressing the P
ARAMETER
button (see section
"7.3 Setting assemblies")!
In the menu item 'Cutting station' , you can change the settings of the cutting station in
the respective assembly.
The illustration below shows an example of the menu for an assembly with the 'Cutting
station' menu item:
Summary of Contents for EVOLUTION LINE
