Manual KHS Mini System Control MASTER
36
8.1.4.8
Error handling
All the errors that occur in the system are sent to the KHS Mini System Control -MASTER-
and are signalled acoustically through a buzzer. It is possible to integrate an alarm relay
(see Chapter 6.2.2.8). In normal operation, the alarm relay is energized ("pulled") with
voltage. If there is an error, the voltage drops and an acoustic signal reports the error.
During this it does not matter what kind of impact the malfunction could have on the
system. The control goes into alarm latching and has to be acknowledged after the
malfunction has been repaired
.
Ill. 8.43 Error display
Ill. 8.44 Acknowledge the error
Ill. 8.42 Acknowledge the buzzer
Switch off / acknowledge buzzer
1 x OK Buzzer off
The control remains in alarm
latching
Error display
The errors of the MASTER / SLAVE
controls are displayed flashing in the
general plan with a lightning icon
Change into the detail view
2 x OK Selected control
Acknowledge error
After the malfunction has been
repaired, the malfunction can
be acknowledged in the detail
display
1 x OK Acknowledge error
