7
MAINTENANCE AND SERVICE
•
Make sure that the equipment is stable and cannot tip over when carrying out maintenance
and service work.
•
Replace damaged or worn parts immediately to reduce the risk of injuries.
•
Carry out maintenance, service and checks in line with recommendations.
•
Only use spare parts with equal performance to reduce the risk of injuries and breakdowns.
Check that all nuts and bolts are tightened after maintenance and service work.
Always test the roller before starting work.
IMPORTANT!
Avoid over-lubricating. Dirt collects easily on exposed grease and causes
increased wear. After lubrication, wipe off excess grease.
TRANSPORTATION AND SET-UP
•
Check that the work area is free from bystanders, children and objects before driving off.
•
Always observe additional caution during transport and moving.
•
Ensure that the equipment or product is well anchored and that available transport lash-
ings are fitted.
•
Always position the load as low as possible. All protruding loads should be well anchored.
•
Respect the risk zones even during transport and moving.
•
Do not permit anyone to walk under suspended loads when carrying out lifts.
•
Trailers used for transport should have brakes in working order.
•
An SMV sign must be attached when travelling on public roads.
•
Check tyre pressure - see information on the sidewalls of the tyres. Do not exceed the
maximum pressure!
•
Always store the equipment or product in a dry place, preferably under a roof, when not
in use.
•
Before long-term storage, the machine should be thoroughly cleaned and lubricated.
•
The drum should be emptied of water before long-term storage.
(Especially important
during winter.)
•
Ensure that the equipment or product is stable and cannot tip over.
•
Never permit children to play at the storage site.
•
Be aware of the tipping risk!
RECYCLING
For scrapping, the equipment/product must be dismantled and transported to
a recycling station designated by your local authority. Contact your local authority
for further information.
Kellfri AB has a policy of continuous product development and therefore reserves the right to
make modifications, e.g. to the design and appearance of the product, without prior notice.
Summary of Contents for 27-V1500
Page 12: ...12 Table of contents NOTES...
Page 13: ...13 Table of contents NOTES...
Page 14: ...14 Table of contents NOTES...
