24
B.) ADJUSTMENT:
UP
AND
DOWN
If the wheel is skewed så that either the upper part (Fig 3) or the lower part (Fig4) of the
wheel is too close to the protective cover:
MEASURE
If the wheel is skewed as shown in FIG. 3, loosen the top adjuster bolt (# 7) with 19mm key
and adjust it upwards until you reach the right height. If the wheel is skewed shown in FIG. 4,
adjust the bolt downwards. It is important that the upper and lower nuts are adjusted simulta-
neously. The same number of turns should be turned on each side.
6.) Perform the previous step if fine adjustment is required when the saw belt is already
tensioned. Turn the wheels and check the distance between the wheels and the protective
cover.
7.) When the wheels are fully aligned, tighten all bolts.
Fig 3
Fig 4
Summary of Contents for 21-SV500E
Page 26: ...26 Table of contents DRAWING I CUTTER HEAD FRAME...
Page 27: ...27 Table of contents DRAWING II HEIGHT ADJUSTER DRAWING III FEET OF CUTTER UNIT...
Page 28: ...28 Table of contents RAWING IV CUTTING HEAD UNIT...
Page 29: ...29 Table of contents RAWING V SAWBAND...
