20
f.) Mount the rail feet on the side of the rails. The rail has 12 holes for the assembly of rail feet
g.)Mount the connecting plate of the for the 2 section outer side of the rail, do not tighten the
bolts yet.
h.) Lift the cutting head unit onto the rail. Warning! The saw mills cutting head is very heavy, be
cautious when lifting the unit. This step is required to be done by at least 2 people.
i.) After installing the unit onto the rail, push the unit forward to check if it rolls smoothly,
adjust the feet or the position of the section if necessary before tightening all bolts. Check the
joint points of the rail, make sure that the sections are aligned with each other before tighten-
ing all bolts.
ASSEMBLY - RAIL FEET
Summary of Contents for 21-SV500E
Page 26: ...26 Table of contents DRAWING I CUTTER HEAD FRAME...
Page 27: ...27 Table of contents DRAWING II HEIGHT ADJUSTER DRAWING III FEET OF CUTTER UNIT...
Page 28: ...28 Table of contents RAWING IV CUTTING HEAD UNIT...
Page 29: ...29 Table of contents RAWING V SAWBAND...
