7
MAINTENANCE AND SERVICE
•
Make sure that the equipment is stable and cannot tip over when carrying out
maintenance and service work.
•
Replace damaged or worn parts to reduce the risk of injuries.
•
Carry out maintenance, service and checks in line with recommendations.
•
Only use spare parts with equal performance to reduce the risk of injuries and breakdowns.
•
All electrical repairs and electrical connections must be carried out by a qualified person.
Check that all nuts and bolts are tightened after maintenance and service work.
Always test the machine before starting work.
IMPORTANT! Check the oil level (gearbox/engine oil) and lubricate grease points regularly!
IMPORTANT!
Avoid over-lubricating. Dirt collects easily on exposed grease and causes increased wear.
After lubrication, wipe excess grease off from couplings.
DANGER!
WARNING: Pressurised oil and fuel leaks can penetrate skin and cause serious
injuries. Do not use your hands to locate leaks. Use a piece of paper or cardboard
to look for leaks.
Kellfri AB has a policy of continuous product development and therefore reserves the right to
make modifications, e.g. to the design and appearance of the product, without prior notice.
TRANSPORTATION AND SET-UP
•
Check that the work area is free from bystanders, children and objects before driving off.
•
Always observe additional caution during transport and moving.
•
Ensure that the equipment or product is well anchored and that available transport
lashings are fitted.
•
Always position the load as low as possible. All protruding loads should be well anchored.
•
Respect the risk zones even during transport and moving.
•
Do not permit anyone to walk under suspended loads when carrying out lifts.
•
Trailers used for transport should have brakes that work.
•
An SMV sign must be attached when travelling on public roads.
•
Check tyre pressure - see information on tyre pages. Do not exceed the maximum pressure!
•
Always store the equipment or product in a dry place, preferably under a roof, when not
in use.
•
Ensure that the equipment or product is stable and cannot tip over.
•
Never permit children to play at the storage site.
•
Be aware of the tipping risk!
RECYCLING
For scrapping, the equipment/product must be dismantled and transported
to a recycling station designated by your local authority. Any liquids should
be collected and transported to a recycling station designated by your local
authority. Contact your local authority for further information.
Summary of Contents for 13-HK777
