Operating manual
5
To set the pyrometer to the terminal mode, simultaneously hold down
the
Ctrl key
and press the
E key
twice in rapid succession.
Direct commands have an assigned key. Example: E for emissivity (epsi-
lon). Submenu settings are shown in brackets. Example:
[MIXED
MODE]
6.2.1 Main menue
After starting the terminal or entering "H", the main menu appears:
------------------------------------------------------------------
Mainmenu
------------------------------------------------------------------
0: [QUOTIENT] .................... E: Quick access EPSILON
1: [LAMBDA 1] .................... A: Quick access FILTER
2: [LAMBDA 2] .................... T: Quick access Ao1 SOURCE
C: [I/O] ......................... Y: Quick access Ao1 SCALE BEGIN
K: [CALIBRATION] ................. Z: Quick access Ao1 SCALE END
M: [MIXED MODE]
H: Show this help-site ........... J: Show diagnosis
W: Show ambient temperature ...... Q: Show calibration data
X: Show measure temperatures ..... P: Show channel parameters
------------------------------------------------------------------
>
6.2.2 Parameter/diagnostic overview
Command "P" shows an overview of the current parameters:
------------------------------------------------------------------
- PA50 AFxx 500-1400C – 00/xxx HM - 28.01.13 -
-
PA50SW001/0 QP 0,95/1,55um Version 01.80 10.02.15 -
------------------------------------------------------------------
MIX function
............... on
Ao 1 source ............. mixed
MIX range ... 500.0 - 2400.0 C
Ao 1 scale .. 700.0 - 1700.0 C
MIX transition 680.0 - 700.0 C
Ao 1 current ...........0-20 mA
1st source .......... lambda 1
Ao 2 source ............... off
2nd source .......... quotient
ctrl source .......... lambda 1
Main Menu
Submenu 1
Submenu 2
Execute the
command
Execute the
command
Execute the
command
press
[RETURN]
or [ESC]
press
[RETURN]
or [ESC]
press
[RETURN]
or [ESC]
Select [KEY]
Select [KEY]
Press []
sste[]
Backspace
Backspace
Enter
Enter
Enter
[ESC]
[ESC]