Keller PYRO CellaTemp PA, Manual, Page: 6 / 12

Operating manual
2
3 Configuration layer Mixed-Mode
The following table the parameters of the mixed-mode function are listed
and describes their function.
Configuration layer
C004
(Mixed-Mode parameter)
Parameter Function Explanation
MIX.
Mixed-mode
OFF
off
ON
on
RNG._
define lower limit of
temp. span
RNG.~
define upper limit of
temp. span
TNS._
Transition range
begin
TNS.~
Transition range end
SRC.1
Select source 1
1. Quelle
L1
Lambda 1
L2
Lambda 2
Q
Quotient
SRC.2
Select source 2.
L1
Lambda 1
L2
Lambda 2
Q
Quotient
SRC.C
Selction of the con-
trolling source
L1
Lambda 1
L2
Lambda 2
Q
Quotient
SAVE
Save Save changes / exit menu
ESC
Escape Discard changes / exit menu
To operate the pyrometer in mixed mode, the corresponding source of
the analog output must be set. Optionally, the scaling (measuring range
start and end) of the analog signal can be adjusted if required.
Configuration layer
C010
(Analog output parameter)
Parameter Function Explanation
AO1.S
Ao1 select source
L1 Lambda 1
L2 Lambda 2
Q ration mode (puotient)
MIX Mixed
((the selected temp. reading source will be
shown on the display)
AOI._
Ao1 define lower
limit of temp. span
AOI.~
Ao1 define upper
limit of temp. span