H5875F5RH
Classic Lion Fountain
STAGE 1
Ensure you have all the correct items
before you begin the assembly
process.
STAGE 2
Locate the brass/metal manifold and
thread the small black nozzles into
each outlet, use an adjustable spanner
to tighten fully (do not over tighten)
STAGE 3
Sit the large hexagonal bowl on two
wooden batons (found Inside the box)
and feed the pump cable through the
central hole and then through the top of
the large pedestal and out through the
bottom. There is a notch in the bottom
of the pedestal for the cable to run
through; this notch should be at the
closest point to the power source.
STAGE 4
Sit the large hexagonal bowl on top of
the large pedestal ensuring it is central,
thread the thin nozzle on to the pump
and push one end of the clear tubing
over the nozzle end.
STAGE 5
Put the small pedestal in the centre of
the hexagonal bowl encasing the pump
and attach the thin black tubing over
each of the black nozzles, push the
wider nozzle into the open end of the
clear tubing ensuring that the longest
length of black tubing is on the top of
the manifold, slide the metal clamp
over the long black tubing and tighten
just enough to hold in place.
STAGE 6
Sit the four face lion column on top of
the small pedestal ensuring it is square
with it and feed all the tubing up into
the cavity, attach an open end of the
black tubing onto each of the nozzles
inside the column, the tubing with the
metal clamp on does not go on to one
of these nozzles.
1 of 2