Keithley TEC SourceMeter 2510, Service Manual, Page: 81 / 120

5-6 Disassembly Models 2510 and 2510-AT
Power module removal
Perform the following steps to remove the rear panel power module:
1. Disconnect the power module's ground wire. This green and yellow wire connects to a
threaded stud on the chassis with a kep nut.
2. Squeeze the latches on either side of the power module while pushing the module from
the access hole.
Fan removal
1. Remove the two nuts that secure the fan to the rear of the chassis.
2. Remove the fan from the chassis.
Instrument reassembly
Reassemble the instrument by reversing the previous disassembly procedures. Make sure
that all parts are properly seated and secured, and that all connections are properly made.
WARNING To ensure continued protection against electrical shock, verify that power
line ground (green and yellow wire attached to the power module) is con-
nected to the chassis.
Also make sure the four bottom case screws are properly installed to
secure and ground the case cover to the chassis.
2510-902-01 (E - Mar 2010)(Service).book Page 6 Tuesday, March 16, 2010 1:04 PM